Publication Details

Category Text Publication
Reference Category Journals
DOI 10.1016/j.chemgeo.2017.07.027
Title (Primary) New biotite and muscovite isotopic reference materials, USGS57 and USGS58, for δ2H measurements–A replacement for NBS 30
Author Qi, H.; Coplen, T.B.; Gehre, M.; Vennemann, T.W.; Brand, W.A.; Geilmann, H.; Olack, G.; Bindeman, I.N.; Palandri, J.; Huang, L.; Longstaffe, F.J.
Source Titel Chemical Geology
Year 2017
Department ISOBIO
Volume 467
Page From 89
Page To 99
Language englisch
Keywords HTC; Hydrogen isotopes; Isotope standards; Hydrous minerals
UFZ wide themes RU3;
Abstract The advent of continuous-flow isotope-ratio mass spectrometry (CF-IRMS) coupled with a high temperature conversion (HTC) system enabled faster, more cost effective, and more precise δ2H analysis of hydrogen-bearing solids. Accurate hydrogen isotopic analysis by on-line or off-line techniques requires appropriate isotopic reference materials (RMs). A strategy of two-point calibrations spanning δ2H range of the unknowns using two RMs is recommended. Unfortunately, the supply of the previously widely used isotopic RM, NBS 30 biotite, is exhausted. In addition, recent measurements have shown that the determination of δ2H values of NBS 30 biotite on the VSMOW-SLAP isotope-delta scale by on-line HTC systems with CF-IRMS may be unreliable because hydrogen in this biotite may not be converted quantitatively to molecular hydrogen. The δ2HVSMOW-SLAP values of NBS 30 biotite analyzed by on-line HTC systems can be as much as 21 mUr (or ‰) too positive compared to the accepted value of − 65.7 mUr, determined by only a few conventional off-line measurements. To ensure accurate and traceable on-line hydrogen isotope-ratio determinations in mineral samples, we here propose two isotopically homogeneous, hydrous mineral RMs with well-characterized isotope-ratio values, which are urgently needed. The U.S. Geological Survey (USGS) has prepared two such RMs, USGS57 biotite and USGS58 muscovite. The δ2H values were determined by both glassy carbon-based on-line conversion and chromium-based on-line conversion, and results were confirmed by off-line conversion. The quantitative conversion of hydrogen from the two RMs using the on-line HTC method was carefully evaluated in this study. The isotopic compositions of these new RMs with 1-σ uncertainties and mass fractions of hydrogen are:

USGS57 (biotite)

δ2HVSMOW-SLAP = − 91.5 ± 2.4 mUr (n = 24)

Mass fraction hydrogen = 0.416 ± 0.002% (n = 4)

Mass fraction water = 3.74 ± 0.02% (n = 4)

USGS58 (muscovite)

δ2HVSMOW-SLAP = − 28.4 ± 1.6 mUr (n = 24)

Mass fraction hydrogen = 0.448 ± 0.002% (n = 4)

Mass fraction water = 4.03 ± 0.02% (n = 4).

These δ2HVSMOW-SLAP values encompass typical ranges for solid unknowns of crustal and mantle origin and are available to users for recommended two-point calibration.
Persistent UFZ Identifier
Qi, H., Coplen, T.B., Gehre, M., Vennemann, T.W., Brand, W.A., Geilmann, H., Olack, G., Bindeman, I.N., Palandri, J., Huang, L., Longstaffe, F.J. (2017):
New biotite and muscovite isotopic reference materials, USGS57 and USGS58, for δ2H measurements–A replacement for NBS 30
Chem. Geol. 467 , 89 - 99 10.1016/j.chemgeo.2017.07.027